Prior to use, wash all parts and boil nipple, nipple ring and vent for 5 minutes.

Disassemble all parts. To remove vent from the bottom cap, grasp pull tabs and pull upward until loose. Clean as soon as possible after each use. Wash in the top rack of dishwasher or hand wash with hot soapy water for about one minute.

Dry thoroughly.

For general maintenance, boil silicone nipple and vent in water for 5 minutes once a week. Dry thoroughly.

ASSEMBLY:

Attach Bottom Cap: Push vent down until the vent is in place. Screw the bottom cap onto bottle.

Attach Nipple. Pull nipple through the nipple ring. Screw the nipple ring onto the top of the bottle.

Attach Cap: Snap nipple cap onto nipple ring to seal nipple. During use, nipple cap attaches onto the bottom cap.

NEVER leave baby unattended with bottle. Do not let a child take a bottle to bed or self-feed for long periods.

To avoid injury do not let baby walk with bottle.

Do not put baby to bed with bottle. Prolonged contact with liquids may cause severe tooth decay. Ask your doctor or dentist.

Do not microwave. Liquid inside can heat unevenly or overheat and burn baby's mouth, even if outside of the bottle feels cool.

To prevent a possible choking hazard, test strength of nipple regularly by pulling hard on the nipple. Inspect regularly, especially when baby is teething. If nipple becomes cracked, torn or shows other signs of wear, discontinue use immediately. Do not attempt to enlarge hole in nipple with a pin or other sharp object, as this will cause tearing.