For soft and hard lenses. For storage of soft (hydrophilic), rigid gas permeable (RGP), or hard contact lenses during chemical disinfection. For use in storage during chemical disinfection only. Do not use during heat disinfection.

Product Number: 055989006734

Before initial use, rinse the case with hot water. Do not use any soaps, detergents, or other household chemicals. After washing, rinse thoroughly with sterile disinfecting solution.1. Fill right lens-well 2/3 full with fresh sterile disinfecting solution, immerse one lens and snap cap tightly shut. Use only fresh contact lens disinfecting solution each time you store your lenses.2. Repeat same procedure with left lens-well and lens.3. Leave lenses in the case for the length of time prescribed by your eye care practitioner. Before wearing, rinse each lens thoroughly in sterile solution as recommended for use with your lenses.4. Rinse your lens case with sterile contact solution (never use tap water) and leave the lens case open to dry after each use. Turn the case over and shake any excess solution out of the case. Be sure that no residual solution remains in the case before you allow it to air dry.5. Replace lens case at least once every 3 months. Contact lens cases can be a source of bacterial growth. Consult solution manufacturer's recommendation for disposal of solution after opening.6. Do not expose your contact lenses to water while you are wearing them.

Lens cases can be a significant source of microbial contamination. To prevent eye infections, lens cases should be cleaned, rinsed, and air dried every day. Caution: Do not try to remove a lens if the lens-well appears dry following the disinfecting cycle. Refill the well with fresh saline solution; re-cap tightly and wait 30 to 40 minutes for the lens to rehydrate. If either lens-well repeatedly dries out or leaks, the case should be replaced. Keep out of reach of children.