Our steamer device will allow you to safely remove your manicures with the steam of acetone or acetone-free nail polish remover. Allows you to remove your gel polish, acrylic gel or colored powder. The maximum temperature is 52 degrees celsius.Includes two containers for measuring liquids and to put inside the device.Includes five spare black tights.You will need 100% pure acetone to use it.Removal time: gel polish 3-5 min., resin and powder 6-8 min., acrylic gel 8-10 min.

Product Number: 810837004429

1. Run the gold file over the surface of your nails;2. Place the plastic container in the bottom of the device and pour in 5 ml of acetone or non-acetone solvent;3. Turn on the steamer device and wait for it to change from H (heating) to S (ready to steam). This step can take up to 2 minutes;4. Place your 5 fingers in the device for about 3 to 5 minutes;5. Switch off the device. Use the buffing block (or the zebra banana file) to remove the residue;6. Turn on the device and wait for the light signal to change from H (heating) to S (ready to steam);7. Repeat steps 4 and 5 until there is no residue.

You must turn off the device when you have reached step #5 (if you plan to repeat step #4) otherwise the device will lose its heat and this will prevent the device from being in H and S mode at the same time.W mode means Warm, you must turn off the device and start over from the starting point. The appliance turns to W when the lid is on top and it is not in use (eg in step 5).You don't have to scrape the natural nail with an orange stick or cuticle pusher to remove residue in step #1. It will damage your natural nails.The steamer box includes two containers as well as five replacement pads.